| Bending test | Change from an initial value L : within10% | Specimen welded on substrate, apply pressure at approx. 0.5mm/s in arrow direction until substrate deformation reaches 3mm, hold for 30s. |
| Adhesion strength | Change from an initial value L : within10% | Apply static load using R0.5 pressing tool in arrow direction to specimen body, hold for 605s. Measure after removing pressure. |
| Vibration | Change from an initial value L : within10% | Vibration frequency 10~55~10Hz, amplitude 1.5mm, 2 hours in each X, Y, Z direction (total 6 hours). |
| Mechanical shock | Change from an initial value L : within10% | Peak acceleration: 981 m/S2, Duration of pulse: 6ms, 3 times in each of 3(X,Y,Z)axes. Specimen fixed on test board. |
| Free fall test | Change from an initial value L : within10% | Specimen fixed on substrate, placed in a 500g box, free fall from 1m height, 3 times in each of three perpendicular directions. |
| Solder ability | 90% minimum of the surface immersed shall be covered. | Terminals immersed in flux for 5-10s. Dip sample into solder bath at 2455 for 30.5s. |
| Resistance to soldering heat | Change from an initial value L : within10% | Reflow soldering method: Preheat 150~180 for 9030s, Peak temp 260 (230 min, 3010s). Test board thickness 0.8mm. Performed twice. Stabilize for 1h under standard conditions before measurement. |
| Dielectric strength | Without damage. | 100V DC applied for 60s between terminal and core. |
| Insulation resistance | 100m or more. | 100V DC applied between terminal and core. |
| Low temperature | Change from an initial value L : within10% | Stored at -403 for 50012h. Measured after 1h stabilization under normal temp/humidity. |
| Dry heat | Change from an initial value L : within10% | Stored at 852 for 50012h. Measured after 1h stabilization under normal temp/humidity. |
| Dump heat | Change from an initial value L : within10% | Stored at 602, 90-95% RH for 50012h. Measured after 1h stabilization under normal temp/humidity. |
| Temperature cycle | Change from an initial value L : within10% | 500 cycles of -40 for 30 min and 85 for 30 min (transit time 2 min). Measured after 1h stabilization under normal temp/humidity. |
| Temperature drift | Inductance temperature coefficient 2000 ppm/ or less | Measured in the range of -25 to 85. |
| Operating temperature range | -40 ~ +125 | Includes product heating temperature. |
| Storage temperature range | -40 ~ +85 (* -40 ~ +60) | In packing state. |
